Telstar 12 Vantage.

Why am I not seeing a bigger difference between the 80cm and the 1m?

Simple answer - while an increase in dish size will increase the strength of the wanted signal, the signal strength of the unwanted signal is also increased by the same amount. This means that the signal to noise ratio (the noise floor in this case being raised thanks to the interfering wideband data signal on the Mid-Mediterranean beam or Euro Spot 3 beam, depending on your source) remains the same between the two conflicting signals, and once you get above a certain signal strength level, signal to noise is what counts for successful reception. As both the wanted & unwanted signals are equally raised in parallel by increasing dish size, you can't make the signal to noise ratio for your wanted reception any better by increasing the dish size and there's really nothing you can do about it at a given location where this conflict exists - the BBC Satback signal is as much interference limited as it is beam limited. There's nothing new in this - the Saorsat service area is limited to the island of Ireland and the western fringes of Britain thanks to a similar interference limiting multi-beam setup on Eutelsat's Ka-Sat - the folks at Dr. Dish tried receiving it in Germany with a 12 metre dish but had no success!

As for receiving BBC Satback in the Caribbean, unless there is a freakish sidelobe to the North Sea beam that is strong enough not to require a dish rivalling those used for professional radio astronmy, then you have no chance of success. Isn't happening. It's the equivalent of trying to trying to receive Ku-Band signals aimed at the Americas in Conentinal Europe i.e. pretty much a no hoper.
 
Hi
Im a new member and not sure of the rules etc. I'm on the Algarve and have lost my satellite reception for UK Tv via the Arqiva BBC satback service. I understand that telesat have an alternative service does anyone know if this will work for my area and any further details Many thanks
Telesat is a Canadian company. Are you thinking of Kabelio which is based in Switzerland? You will need a Swiss contact though.
 
Telesat is a Canadian company. Are you thinking of Kabelio which is based in Switzerland? You will need a Swiss contact though.
Telstar 12 Vantage is a Telesat satellite.
 
Telstar 12 Vantage is a Telesat satellite.
But that reply doesnt make any sense to the question asked does it seeing as Testra dont have any other UK services that the OP might be interested in
 
I am on the edge of the beam (north sea) but I cannot scan the BBC satback bouquet.
strangely the AGC signal indicates a strong signal on the 11043V?
I configured the transponder as indicated in satxml.
Can someone who receives it without problem send me a copy of their lamedb and satxml?
THANKS
 
my current scan
 

Attachments

  • 15,0° West 7.JPG
    15,0° West 7.JPG
    175.6 KB · Views: 69
  • 15,0° West 5.JPG
    15,0° West 5.JPG
    228.2 KB · Views: 66
  • 15,0° West 6.JPG
    15,0° West 6.JPG
    191.1 KB · Views: 53
  • 15,0° West 4.JPG
    15,0° West 4.JPG
    245.3 KB · Views: 49
  • 15,0° West 8.JPG
    15,0° West 8.JPG
    158 KB · Views: 54
  • 15,0° West 9.JPG
    15,0° West 9.JPG
    194.7 KB · Views: 64
Is anyone with a GSE-capable card able to get a capture of 12532 or 12542 H SR: 640 DVB-S2 16APSK (I've seen the frequency listed differently in a couple of places). Pseudo TS from a TBS card would be fine, or if you can see the IP content that would also be very interesting.

Unfortunately some trees here stop me from being able to get 15°W on the motorised setup, I'm very curious as to whether it might contain a DAB feed, the data rate is around what would be expected for a single mux.

Thanks!
 
In the morning, I wasn't getting a signal on either of those two frequencies. Now, in the afternoon, I'm getting some signal (7.5 dB, although it varies slightly) on frequency 12542 H, but it's not enough to lock on. I'm going to check tonight to see if I can get something better and lock on that frequency.

Captura de pantalla 2025-10-16 170557.webp
 
With those signal levels in EBS Pro, I would have blocked it. I hadn't thought to try it before.

When I get the signal levels back, if EBS Pro allows it (if it even allows it), I'll record the full TS and upload it to you.

Captura de pantalla 2025-10-16 180518.webp
 
The values are black (no green), i.e. without LOOK, only the estimated value (similar to in CS status - NO LOCK).
 
Back
Top